Source Technologies STM.58B Manual do Utilizador

Rev. 1.0All specifications are subject to change without noticeMOBILE PRINTERMODEL : STm.58b

1617SerialUSB4-2 Interface Cable Connection1. Connect USB or Serial cable into the cable connector on the printer.2. Connect the interface cable into

18196.CertificationPrinting Method Direct ThermalPrinting Speed 80mm/secResolution 203 DPI X 203 DPICharacter Font A (12X24), Font B (9X17)Character pe

20217. Setting up the softwarePlease refer to the programming manual included in CD. CAUTIONAntenna shall be mounted in such a manner to minimiz

1Table of Contents 1. Unpacking2 2. Product overview 3 3. Usage and Installation4 3-1. Control panel usage4 3-2. Battery Installation5 3-3

232. Product overview Paper feed buttonOpen ButtonPower switch SERIALUSB Belt clip holeBatteryDC Power FrontRear1. Unpacking Printer BatterySe

451. Align battery hook as shown in the picture2. Push the battery into the printer until it locks in place.NOTEAs the battery is not charged at the t

67NOTE1. Unless the exclusive charger is used provided by the manufacturer, the printer can be damaged, and the manufacturer is not liable for th

89Connect the car cigar JACK charger into the printer or battery holder.3-6 Usage of Cigar Jack for chargingPrinterBattery holderNOTEUse the Cigar Jac

10111 234Press the PUSH button to open the paper coverPull a short length of paper out of the printer and close the cover.Insert the paper in the righ

12131 23NOTETurn off the power pressing the power button for approximately 3 seconds.The printout is produced.While you are pressing the FEED button,

1415Insert and swipe the card in the direction of the arrow as shown in the picture.3-11 MSR usageOptionalWhen the printer is installed initially or w